DirectAccess WinRM Conflicts and Errors

Introduction

When installing DirectAccess for the first time, an administrator may encounter the following error message while running the Remote Access Setup wizard.

Error. The client cannot connect to the destination specified in the request. Verify that the service on the destination is running and is accepting requests. Consult the logs and documentation for the WS-Management service running on the destination, most commonly IIS or WinRM. If the destination is the WinRM service, run the following command on the destination to analyze and configure the WinRM service: “winrm quickconfig”.

DirectAccess WinRM Conflicts and Errors

Troubleshooting

Running winrm quickconfig in an elevated PowerShell command window returns the following message.

WinRM service is already running on this machine.
WinRM is already set up for remote management on this computer.

DirectAccess WinRM Conflicts and Errors

Clicking Check prerequisites again does not resolve the error message.

Post-Installation Errors

If DirectAccess is already installed and working properly, an administrator may encounter a scenario in which the operations status page displays nothing, yet remote DirectAccess clients are connected and able to access corporate resources without issue.

DirectAccess WinRM Conflicts and Errors

In addition, clicking Edit on Step 2 in the Remote Access Management console and choosing Network Adapters produces an error message stating “An error occurred when validating interfaces”. You can select a network adapter from the drop-down list, but the Next and Finish buttons are grayed out.

DirectAccess WinRM Conflicts and Errors

Conflicts with WinRM

These errors are commonly caused by a conflict with WinRM Service settings enforced via Active Directory group policy. To confirm this, open an elevated PowerShell command window run the winrm enumerate winrm/config/listener command. The listener configuration source will be listed as GPO.

DirectAccess WinRM Conflicts and Errors

The administrator will also find the presence of the following registry keys on the DirectAccess server.

HKLM\Software\Policies\Microsoft\Windows\WinRM\Service\AllowAutoConfig
HKLM\Software\Policies\Microsoft\Windows\WinRM\Service\IPv4Filter
HKLM\Software\Policies\Microsoft\Windows\WinRM\Service\IPv6Filter

Resolution

To resolve this conflict, prevent the GPO with this setting from being applied to the DirectAccess server(s). You will find this GPO setting in the Group Policy Management console (GPMC) by navigating to Computer Configuration -> Policies -> Administrative Templates -> Windows Components -> Windows Remote Management (WinRM) -> WinRM Service and setting the state of Allow remote server management through WinRM to Not configured.

DirectAccess WinRM Conflicts and Errors

Additional Resources

DirectAccess and Windows 10 Better Together

DirectAccess and Windows 10 in Education

VIDEO – DirectAccess and Windows 10 in Action 

BOOK – Implementing DirectAccess with Windows Server 2016

Leave a comment

Leave a Reply

Discover more from Richard M. Hicks Consulting, Inc.

Subscribe now to keep reading and get access to the full archive.

Continue reading